Hi

Oh, my mistake I only downloaded veye_mipi_i2c.sh, I didn't realise it called i2c_read, i2c_write.
Sorry I will download all files tomorrow and try again.

thanks
Nigel

Hi There

I'm trying to use the I2c tool to control the VEYE-MIPI-IMX327s on the Google coral dev board.

I downloaded veye_mipi_i2c.sh from your Github repository.

But when I test it with ./veye_mipi_i2c.sh -r -f sensorid -b 1

I get

./veye_mipi_i2c.sh: line 134: ./i2c_read: No such file or directory
./veye_mipi_i2c.sh: line 136: ./i2c_read: No such file or directory
./veye_mipi_i2c.sh: line 138: ./i2c_read: No such file or directory
r sensor id is IMX7f7f; TWO board

similarly if I test with ./veye_mipi_i2c.sh -r -f dhver -b 1

I get
./veye_mipi_i2c.sh: line 121: ./i2c_read: No such file or directory
hardware version is 0x7f

I'm probably missing something or doing something totally wrong so any advice would be much appreciated.
Am I meant to enable I2c as per the raspberry pi? I couldn't see a shell to do that in your repository.

kind regards
Nigel.

Hi

Thank you, that worked, camera is streaming now.
Thanks for your help.

regards
Nigel.

Hi There

I followed your instructions for installing the VEYE-MIPI-IMX327S onto the Google coral dev board but when I navigate to /boot to

sudo cp fsl-imx8mq-phanbell-<camera_name>.dtb fsl-imx8mq-phanbell.dtb

as per your instructions no such file exists.

The contents of the directory are as follows

mendel@zippy-tang:/boot$ ls
boot.scr fsl-imx8mm-columbia.dtb fsl-imx8mq-phanbell-m4.dtbo Image overlays.txt u-boot.imx
config-4.14.98-imx fsl-imx8mq-phanbell.dtb fsl-imx8mq-yorktown.dtb lost+found System.map-4.14.98-imx vmlinuz-4.14.98-imx

Any advice much appreciated.

kind regards
Nigel.