Error with camera_i2c_config and IMX462
-
Hi,
I am using a Pi4B which I have configured prior to the Veye_Mipi_327 camera. Now I want to test the new IMX462 module. During installation I get the following error:pi@M1000:~/imx462/bayercam_for_print3d/i2c_tools $ ./camera_i2c_config -b 10 setting GPIO for board revsion: c03112 kernel ver:5 Raspberry Pi3B / Pi3B+ / 3A / 4B(1G/2G/4G/8G) ./camera_i2c_config: 120: ./camera_i2c_config: ./rpi3-gpiovirtbuf: Permission denied Use i2c-10 for the sensor (-y 10)Any ideas what can cause this?
-
@seka Sorry. Found out again myself:
sudo chmod +rwx rpi3-gpiovirtbuf... did the trick
Maybe and hopefully someone else will benefits from my stupid questions, though I doubt it haha...
-
@seka
Thank you for sharing.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login