e.g my post here:
http://forum.veye.cc/topic/21/camera-i2c-configuaration-for-sync-mode
I just have blue images like the post here:
http://forum.veye.cc/topic/22/i-want-to-synchronize-the-two-cameras-in-sync-mode
But i have 8 cameras connected.
Do I also connect the boards: FPD-LINK3-2RX?
or is it the i2c configuration?
@veye_xumm sorry i forgot to upload the blue image
Hello,
i have my own developed carrier board for an Jetson TX2 with an DS90UB964TRGCTQ1 chip. What do i have to do to make the IMX307 cameras with FPD-LINK3-TX run?
kind regards
@veye_xumm Does veye still have such a system in stock? I would like to order a set again. or will the system be available again this year
@veye_xumm ok i am understand, just these three formats
thank you
@veye_xumm is it possible to set other video formats? for example when i change the devicetree?
regards
Hello,
how to use the Sensor crop mode of the IMX307 Camera.
Thanks a lot
@veye_xumm
i have installed the new version. it looks good for now. One question do i need to set the fpdlink-settings after each reboot?
@veye_xumm sorry i forgot to upload the blue image
@veye_xumm
A lens is connected on all camera. If i switch back the configuration to "free run" on each camera, all images look normal.
@veye_xumm
No special lens on the cameras - just the standard from veye
Here is an image
