@lin 不客气。

@veye_xumm OK，明白，多谢！

@seka OK~

@dan_lionking You are welcome.

@veye_xumm 重新插拔了下线，目前已经能正常读到，看来应该是线没有接好

@veye_xumm Thanks!

@lkarthus said in IMX307如何调试图像参数？IMX307和IMX335如何同时使用？: luochen52@163.com 已发送。

@joe Of course.

@lin 相机触发模式出图和流模式出图，对你的程序接收图像而言，没有区别啊！

@veye_xumm 是的 非阻塞缓存后写图，已经解决了。抓拍的图像基本模拟一次就有一张抓拍，因为闪一次时间是1ms 所以只抓到一张也是合理的。

@xu 识别到产品型号了，正常。

@xLWvU7mX As planned, the interface of our redesigned camera module will be fully compatible with our current MV series products. You can check its pinout from this link: https://wiki.veye.cc/index.php?title=MV-MIPI-GMAX4002M_Data_Sheet. Based on this, our ADP-MV1-V2 adapter board will be fully compatible and will convert the signals of the new GX-MIPI-IMX662 to match the legacy version. You can refer to the interface definition of the ADP-MV1-V2 here: https://wiki.veye.cc/index.php?title=ADP-MV1-V2_Adapter_Board_Data_Sheet

@robot ok

@fire Yes, raspivid and raspistill works too on Ubuntu.

@npcdna 这个问题提出已经很久了，一直没有更新状态。 我会将状态标记为解决，如果需要，可以再次跟帖，或者直接打开问题。

@chjchoi I think this place means that the 954 chip is not detected properly on the i2c.

@veye_xumm 感谢

@vladimi-zheng 没有关系。

@veye_xumm That's right. It worked with the lens. Thank you very much for your technical support.

@veye_xumm 好的好的，感谢您的建议