@张志伟 按照我我们wiki上步骤去调用yavta存图一定是可以的。你把你用的命令发出来我看看。

@picantepeperoni We have had customers attempt similar approaches, but the results were not significant.

@stiwana

@stiwana said in MV-MIPI-GMAX4002M compatibility with Jetson Xavier NX, Orin NX:

Can I use the commonly available RPi-zero Mipi camera FPC to connect the camera to Jetson Orin NX?

Yes.

@stiwana said in MV-MIPI-GMAX4002M compatibility with Jetson Xavier NX, Orin NX:

Is there anything else I can do to increase the low-light performance? Did i miss another setting that can help?

To improve performance in low-light conditions, the main methods are:

Use a lens with a smaller F-number. In either automatic or manual exposure mode, extend the exposure time to the maximum duration you can tolerate. (Note that the exposure time cannot exceed the reciprocal of the frame rate, so you may need to adjust it accordingly based on your specific situation.) Increase the gain.

@stiwana said in MV-MIPI-GMAX4002M compatibility with Jetson Xavier NX, Orin NX:

I do notice that at higher gain the images get these fixed patterns probably due to the FPNU or PRNU of pixel array. Is there a way to do a calibration on the image sensor to make the image response more uniform?

Sorry, we don't offer this algorithm yet.

@stiwana said in MV-MIPI-GMAX4002M compatibility with Jetson Xavier NX, Orin NX:

Is there any gstreamer pipeline I can use to get 12 bit image stream out and display it as 8bit in real time?

Sorry, we don't provide this kind of program either.

@veye_xumm 明白了，谢谢！！

@国电富通 OK

@veye_xumm Thanks for updates. WIll check with Seeed studio how to upgrade the firmware.

@joe yes

@wangdada 这两个是一样的，只是叫法不同而已。

@hujun 是的

@veye_xumm ok. Will try again.

@mjyc 板子寄过来我们帮你看看。我这边bulleye是正常用的。建议你也更新到bulleye系统。

@yun 你这个i2c找不到设备啊。 方便的话把整套模组寄过来我们检查一下。

@lb 如果你使用的Xavier nx是nVidia官方的，建议你直接使用我们提供的编译好的版本。
如果你确实需要重新编译，建议你替换dtb的时候，同时安装ko。然后引出启动串口的打印信息找一下原因。

@liuyue 已私信。

LivePushStream_2024-04-21_04.49.41.300_04.49.44.300_流星数1.jpg

http://hainanftp.net/lx/LivePushStream_2024-04-21_04.49.41.300_04.49.44.300_流星数1.mp4

@lin 不客气。

@veye_xumm OK，明白，多谢！

@xu 识别到产品型号了，正常。

@veye_xumm Thanks!

@lkarthus said in IMX307如何调试图像参数？IMX307和IMX335如何同时使用？:

luochen52@163.com

已发送。