Perfect, thank you! Now i can run the commands from the source folder. If I may, I highly suggest including all steps in the guide. To some point its very precise, e.g. navigate using cd, access raspi-config. But then a lot of this info is missing. But now it works for me at least:)
Again, thanks!
Kind regards,
Jgg
Thank you for getting back to me.
Output from . /veye_raspipreview -t -1 :
before create camera com time out -1
Hardare version: 9020e0
before create camera com
mmal: mmal_component_create_core: could not find component 'vc.ril.rawcam'
mmal: Failed to create camera component
mmal: main: Failed to create camera component
Output from /raspberrypi/D_mipi_rpi/python_demo/ python preview.py:
Load libdmipicam fail.
What do you mean by recompile veye_raspiview? How do I do this?
I am running Buster OS on rpi 3A, 32bit (armv7l).
I would really appreciate if I could get a clear explanation and step-by-step solution to get the camera to live stream and show the output.
Kind regards
Jgg
@veye_xumm I connected the camera to my rpi and enabled camera and i2c in raspi-config. I have cloned the software toolkit from github, navigated to the sw toolkit /bin folder and made the tools executable using the chmod +x command. At this point I should be able to use the commands like ./veye_raspipreview -t -1 to live stream. But the camera is not detected. I do have another rpi setup with a breakout board for power management and an sd card running a specific code made for using the veye cameras. When i connect the camera to this rpi it works as expected. But, like i said, with a rpi 3 clean install sd card and just ribbon cable (and 5v + ground fpr 327E) the camera is not detected and I can not figure out why.. My impression from the guide and the little information i can find in english online is that this should be plug and play. If you could supply me with a clear and concise guide for how I can connect the 327E to a Rpi 3A (with specifications of OS, sw and firmare etc, if needed) and just do a live stream to vlc or similar it would be highly appreciated. I am powering the rpi with a standard rpi adapter (5.1V, 2.5A).
Hello.
I have several veye camera modules and raspberry pi 3A and B. I know the camera and ribbon cable work properly, at least for my VEYE-MIPI-327E. I also have an VEYE-MIPI-327S.
I am struggling to set up anything with these cameras on rpi. I just want, first and foremost, to do live streaming of the camera on my rpi 3A. I have followed the info in this guide
https://wiki.veye.cc/index.php/VEYE-MIPI-290/327_for_Raspberry_Pi
But either there is something i dont understand or there are something wrong or something not stated in this guide. I am completely in the dark here...
Could i please get some help on how to use these cameras?
Kind regards,
Jgg