@veye_xumm 你好，imx622模组什么时候可以量产，我们需要一款1080P60帧的低照度摄像头模组。盼复。

@veye_xumm
Hi again! Well yeah, i made some research yesterday, after my question, and it become obvious, that it is not possible to direct connect not MV-MIPI-IMX178M nor existing adapter board to Khadas Edge2. Pin outs are not nearly the same.

So i decided to make my own adapter board - it's quite easy. But i have some questions to avoid mistakes.

So if i will properly connect all DATA lines, CLK and I2C to Edge2 and route all other signals to dedicated 2,54 header will it be enough to make it work? Power supply will be external and enable signal i want to give by simple switch. Can you give me minor instructions or, maybe, link that explains how to port your driver to another platform? Cause i never did that...

Thanks in advance.

PS: Did you ever work with CCD matrices? For some scientific cases they are preferable.

@veye_xumm Glad to hear that! I would like to test it as soon as possible.

@rob77 You are welcome.

@erm
No， This camera has ISP built-in，it support UYVY output only.

@rob77 👍

@pimat correct.

Is available in 327 or 462?

@salva OK

@veye_xumm 好的吧，感谢

@raphael correct

@maponarooo
Thank you for the reminder, I've modified it.
The file should have a tar.gz suffix instead of tgz.

@dan_lionking

Due to some problems with the bsp of rk3399. http://wiki.veye.cc/index.php/VEYE_MIPI_327_for_Nano_Pi_4_ubuntu#Exsiting_bugs

After we have transport VEYE-MIPI-327 into rk3399, we found these problems and then abandoned the rk platform.

@siderat said in imx327e coonectors CSI cable:

The camera has two connectors for connecting a cable. Upper wide, lower narrower. I am using PI. And I connect the cable to the top connector. Can you connect to the bottom connector too?

Only one of these two connectors can be used at the same time.

@thn Never mind, this can be ignored.

@hiro999 http://wiki.veye.cc/index.php/FFC_Cable

@xzh
你好，
这个capture的功能并不是配套triggger模式的。其功能是从流模式下当前视频流中取出一帧图像。
使用trigger模式，建议使用D_start_yuv_stream函数，注册一个回调函数。然后就会一直处于等待状态。有触发信号之后，就会收到回调函数。

@veye_xumm 好的謝謝您

@nathan-sinclair Sorry, no plans at this time.